MIC2561-1YM belongs to the category of integrated circuits (ICs).
This product is commonly used as a level translator and voltage level shifter in electronic circuits.
The MIC2561-1YM is available in a small outline package (SOP) with 8 pins.
The essence of MIC2561-1YM lies in its ability to facilitate communication between devices operating at different voltage levels.
This product is typically packaged in reels or tubes, with a quantity of 2500 units per reel/tube.
The MIC2561-1YM has a total of 8 pins, which are assigned specific functions:
The MIC2561-1YM utilizes a combination of level shifting circuits and control logic to facilitate bidirectional voltage translation. The automatic direction sensing feature detects the direction of data flow and controls the internal circuitry accordingly. When the OE pin is low, the IC is enabled, allowing data transmission between the input/output pins of the two channels.
The MIC2561-1YM finds application in various fields where voltage level translation is required. Some specific application areas include:
These alternative models offer similar functionality to the MIC2561-1YM and can be considered as alternatives based on specific application requirements.
In conclusion, the MIC2561-1YM is a versatile integrated circuit that enables bidirectional voltage translation between different voltage domains. Its wide supply voltage range, high-speed operation, and low quiescent current consumption make it suitable for various applications in different fields.
Sure! Here are 10 common questions and answers related to the application of MIC2561-1YM in technical solutions:
Q1: What is MIC2561-1YM? A1: MIC2561-1YM is a high-speed, low-power RS-485/RS-422 transceiver IC.
Q2: What is the operating voltage range of MIC2561-1YM? A2: The operating voltage range of MIC2561-1YM is typically between 4.5V and 5.5V.
Q3: What is the maximum data rate supported by MIC2561-1YM? A3: MIC2561-1YM supports a maximum data rate of 20Mbps.
Q4: Can MIC2561-1YM be used for both RS-485 and RS-422 applications? A4: Yes, MIC2561-1YM can be used for both RS-485 and RS-422 applications.
Q5: Does MIC2561-1YM have built-in ESD protection? A5: Yes, MIC2561-1YM has built-in ±15kV ESD protection on the RS-485 input/output pins.
Q6: What is the typical supply current of MIC2561-1YM? A6: The typical supply current of MIC2561-1YM is around 300µA.
Q7: Can MIC2561-1YM operate in half-duplex mode? A7: Yes, MIC2561-1YM can operate in half-duplex mode.
Q8: What is the maximum number of nodes that can be connected in a network using MIC2561-1YM? A8: MIC2561-1YM supports up to 32 nodes in a network.
Q9: Is MIC2561-1YM compatible with 3.3V logic levels? A9: No, MIC2561-1YM is not directly compatible with 3.3V logic levels. Level shifting may be required.
Q10: Does MIC2561-1YM have thermal shutdown protection? A10: Yes, MIC2561-1YM has built-in thermal shutdown protection to prevent overheating.
Please note that these answers are general and may vary depending on the specific application and usage scenario. It's always recommended to refer to the datasheet and consult the manufacturer for detailed information.